• Name :Raymond Mill In Gypsum Wallboard
  • Abstract:

Introduction

Application:

Operation order of stopping operation for Gypsum Wallboard Raymond Mil

One of the problems in the grinding production of Gypsum Wallboard Raymond Mil is to prevent friction between the grinding disc and the grinding roller. The distance between the grinding disc and the grinding roller is not far from each other. When there is material between the two, there will be no collision between them. But when the material layer in the middle becomes thin or the material is brittle and the honor breaks, it is easy to cause the collision between the grinding disc and the grinding roller because of the uneven force. This collision will not only lead to the wear of the two wear-resistant parts, but also cause the collision. Will cause the machine to vibrate, serious damage to other components. This is the reason why the user should pay attention to the thickness of the material layer, whether the material is fragile and whether there will be & ldquo; plough material & rdquo; phenomenon in the process of grinding production of Gypsum Wallboard Raymond Mil.

When the Gypsum Wallboard Raymond Mil stops grinding, the material in the grinding chamber of the Gypsum Wallboard Raymond Mil is stopped before the Gypsum Wallboard Raymond Mil stops grinding because the order of shutting down the crusher in the grinding production system of the Gypsum Wallboard Raymond Mil is to shut down the crusher first, and then wait until all the material enters the Gypsum Wallboard Raymond Mil and is grinded completely by the Gypsum Wallboard Raymond Mil. Layers will be less and less, the reduction of the material layer will lead to contact friction between the roller and the grinding disc, resulting in vibration of the machine, the damage of parts in the machine.

In order to reduce the above grinding phenomenon, protect the normal operation of Gypsum Wallboard Raymond Mil, increase its service life, so users need to operate in a fixed grinding order. The grinding sequence of the Gypsum Wallboard Raymond Mil is: reducing material, reducing air, reducing the pressure of the mill roll, lifting the mill roll and dropping the roll again.

This process is completed by the system itself, generally before the system stops working, the material will be less and less as the crusher stops working, this process does not require the user to complete deliberately. The air reduction begins when the materials entering the Gypsum Wallboard Raymond Mil begin to decrease, because the materials from the crusher to the Gypsum Wallboard Raymond Mil need to pass through the belt conveyor, hoist, silo, closed vibration feeder, etc., until the material in the silo is gone, the user can reduce the air accordingly. After reducing the air, the material layer in the Gypsum Wallboard Raymond Mil has basically begun to reduce, so to reduce the pressure of the mill roll, reduce the pressure of the mill roll is actually to stop the power supply of the Gypsum Wallboard Raymond Mil main engine, the Gypsum Wallboard Raymond Mil grinding speed is very fast, after the power supply is cut, the material inside the mill is grinded completely. When the main engine stops, the user can lift the roller. The hydraulic device and the pressure device in the Gypsum Wallboard Raymond Mil are used to switch the roller. The pressure can open the roller, and the pressure reduction can close the roller.