• Name :Raw Mill In Cement Plant
  • Abstract:

Introduction

Application:

Cement Raw Mill work failure solution

In the process of using the Cement Raw Mill, the fault is a major factor that plagues normal production. The occurrence of the fault will cause the production to stop, which has a great impact on normal production. The occurrence of the fault caused the machine to stop the inspection, and also caused the direct increase of the maintenance cost. Therefore, we should pay attention to the use of the Cement Raw Mill during production to reduce the problem of failure.

For the user, how to reduce a big problem when the fault occurs. The emergence of Cement Raw Mill failure is like a nightmare, how to avoid it? Undoubtedly, reasonable maintenance will reduce the failure rate, so we need reasonable maintenance, good maintenance, and good work.

Then, it is necessary to add lubricating oil to each fueling point every day according to the requirements of the Cement Raw Mill. Only in this way can each bearing be sufficiently lubricated and prolong the bearing life. At the time of starting, the friction torque between the axle and the bearing should be restrained, and the moment of inertia of the rotating cylinder and the material should be restrained. Therefore, the motor with a large starting torque should be selected. Clean the residual material in the fuselage, turn off the dust collector, close the main power supply after comparison, complete the production operation, and add the butter to the main machine and the reducer bearing seat every month to ensure the lubrication of the bearing.

If there is a power outage, the heat source should be turned off. The machine naturally cools down and cleans the equipment. After each work, it is necessary to clean the residue in the equipment in time to increase the temperature rise rate. Checking the main unit of the Cement Raw Mill, reducer, dust collector, fan and other devices to lubricate all bearings and friction surfaces, these have a very important impact on the use effect. When we are in production, we must pay great attention to these production phenomena. In the production, we must pay attention to the vibration situation, which will have a great impact on the quality of production. We should not take it lightly, but should pay attention to it so as not to affect the effect and efficiency of production.

In production, it is very important to simply adhere to the above points every day, which can greatly reduce the frequency of failure of the Cement Raw Mill and achieve safe and stable production.